How to improve your condensing gas boiler’s efficiency (and save money)
Almost all new domestic gas boilers fitted after 1st April 2005 are condensing boilers. These boilers are substantially more efficient than the previous generation of boilers. This is because some heat from the very hot flue gases is used to boost the temperature of the water being pumped out to the central heating radiators thereby saving energy. This heat is captured by cooling and partly condensing the flue gases as they come into contact with the cooler water returning from the radiators. However, this process will only work correctly if the returning water, and therefore the outgoing water as well, is not too hot. It does not seem to be well known that many condensing boilers, because they are installed either with a high factory setting or most installers do not understand the implications, supply water to radiators that is too hot. This means that most condensing boilers are only 75-85% efficient in practice when they should be 92-94% efficient. An energy saving of 6.4-8% is achievable and is one more way to cut your greenhouse emissions.
It is actually quite simple for a homeowner to adjust the boiler flow temperature, as it is called, to the optimum setting of 60°C for older houses when the boiler will be nearer to 92% efficient (50°C may even be suitable for houses built after 2010). To be clear, this is quite different from setting the temperature of your hot water at the tap or of your room thermostat.
If you have a condensing combination (or combi) boiler what you need to do is explained here and in more detail here. *
However, if your boiler system has a cylinder which stores hot water it is not a condensing combi boiler but a condensing regular (or system) boiler. This introduces another factor. The Health and Safety Executive (HSE) says that Legionella bacteria, which can be fatal to humans, multiply where water temperatures are between 20-45°C. The bacteria are dormant below 20°C and do not survive above 60°C. Therefore, water supplied to a cylinder with a flow temperature of a few degrees over 60°C, should ensure that a domestic hot water system remains safe, especially if all hot water outlets are used regularly. If you have a thermostat fitted to the cylinder itself, usually one third of the way up the tank, that can be set to 60°C.
Importantly, the same advice, about how to reduce the flow temperature, applies in the case of a condensing regular boiler as for a condensing combi boiler. Just try it, although it might not work for some older condensing boilers in which case just return to the original settings.
Lastly, take care following the above advice if there are vulnerable people in your household. Reducing the boiler flow temperature may lower room temperatures in some circumstances.
Blog written by Dr B Whitmarsh, one of the Scientific and Technical Advisory Panel volunteers for WinACC.
*If you are unsure at any point then we do not recommend trying to adjust your boiler yourself, ask a professional to come and take a look.